Very nice gesture Gary; hopefully someone will find it useful

 
  _____  

From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Gary
Nylander
Sent: November 21, 2013 10:01 AM
To: cnc-list@cnc-list.com
Subject: Stus-List Datamarine stuff FREE

 

I have a Datamarine Link 5100 system - appears to be complete. Came from my
SO's late sister - must have been taken out before they upgraded and
embarked on a voyage south.

 

Datamarine 5100 control head, Display unit with digital speed and depth,
analog wind; DX111 depth, SX 120 speed, wind speed/direction mast top unit,
coax cable, through hull speed and depth sensors....

 

Yours for the cost of shipping, I have no need.

 

Gary Nylander

Maryland

 

 

----- Original Message ----- 

From: Robert <mailto:robertabb...@eastlink.ca>  Abbott 

To: cnc-list@cnc-list.com 

Sent: Wednesday, November 20, 2013 9:13 AM

Subject: Stus-List Muffler

 

John:

I replaced the SS muffler this past Spring.....don't remember the exact
measurements put similar to yours.  

I replaced it with a Vernalift resin muffler....slightly bigger (2" higher)
muffler but with the same 2" inlet and 1 1/2" outlet.  I will try to find my
receipt which will have the part # if that helps you.  Bottom line,
Vernalift makes a resin muffler with a 1/1/2" outlet.  I didn't want to get
into adding hose adapters as my exhaust hoes was replaced last year and it
is 1 1/2".  There are no back pressure issues to worry about with the 1 1/2"
outlet with these small marine diesel engines. 

Bob Abbott
AZURA
C&C 32 - 84
Halifax, N.S.








On 2013/11/20 9:00 AM, John and Maryann Read wrote:

The stainless muffler has finally given up the ghost.  It is 6 ¼ round, 2
inch side inlet and 1 ½ inch top outlet, 9 inches high and the base is 7
inches square.  Any suggested sources??  Vernalift by Centek Industries
makes a close copy but the outlet is 2 inch.  On a related note, any
thoughts on why the outlet is smaller than the inlet and does this create
any backpressure issues??  The engine outlet is 2 inch.  On the other hand,
this set up has worked well for 30 years so it can’t be all bad  :-)

TIA

John and Maryann

Legacy III

1982 C&C 34

Noank, CT






_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com

 


  _____  


_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com

  _____  

No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.2247 / Virus Database: 3629/6354 - Release Date: 11/21/13

_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com

Reply via email to