If I recall correctly, Vernalift were able to custom make a muffler for me that replicated the size of the muffler and inlet/outlets of the old Vernalift that disintegrated.
Jonathan _____ From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Robert Abbott Sent: Wednesday, November 20, 2013 9:14 AM To: cnc-list@cnc-list.com Subject: Stus-List Muffler John: I replaced the SS muffler this past Spring.....don't remember the exact measurements put similar to yours. I replaced it with a Vernalift resin muffler....slightly bigger (2" higher) muffler but with the same 2" inlet and 1 1/2" outlet. I will try to find my receipt which will have the part # if that helps you. Bottom line, Vernalift makes a resin muffler with a 1/1/2" outlet. I didn't want to get into adding hose adapters as my exhaust hoes was replaced last year and it is 1 1/2". There are no back pressure issues to worry about with the 1 1/2" outlet with these small marine diesel engines. Bob Abbott AZURA C&C 32 - 84 Halifax, N.S. On 2013/11/20 9:00 AM, John and Maryann Read wrote: The stainless muffler has finally given up the ghost. It is 6 ¼ round, 2 inch side inlet and 1 ½ inch top outlet, 9 inches high and the base is 7 inches square. Any suggested sources?? Vernalift by Centek Industries makes a close copy but the outlet is 2 inch. On a related note, any thoughts on why the outlet is smaller than the inlet and does this create any backpressure issues?? The engine outlet is 2 inch. On the other hand, this set up has worked well for 30 years so it cant be all bad :-) TIA John and Maryann Legacy III 1982 C&C 34 Noank, CT _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
