I'll take it!
Joe Della Barba Coquina THANKS!!!!!!!!!!! From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Gary Nylander Sent: Thursday, November 21, 2013 9:01 AM To: cnc-list@cnc-list.com Subject: Stus-List Datamarine stuff FREE I have a Datamarine Link 5100 system - appears to be complete. Came from my SO's late sister - must have been taken out before they upgraded and embarked on a voyage south. Datamarine 5100 control head, Display unit with digital speed and depth, analog wind; DX111 depth, SX 120 speed, wind speed/direction mast top unit, coax cable, through hull speed and depth sensors.... Yours for the cost of shipping, I have no need. Gary Nylander Maryland ----- Original Message ----- From: Robert Abbott<mailto:robertabb...@eastlink.ca> To: cnc-list@cnc-list.com<mailto:cnc-list@cnc-list.com> Sent: Wednesday, November 20, 2013 9:13 AM Subject: Stus-List Muffler John: I replaced the SS muffler this past Spring.....don't remember the exact measurements put similar to yours. I replaced it with a Vernalift resin muffler....slightly bigger (2" higher) muffler but with the same 2" inlet and 1 1/2" outlet. I will try to find my receipt which will have the part # if that helps you. Bottom line, Vernalift makes a resin muffler with a 1/1/2" outlet. I didn't want to get into adding hose adapters as my exhaust hoes was replaced last year and it is 1 1/2". There are no back pressure issues to worry about with the 1 1/2" outlet with these small marine diesel engines. Bob Abbott AZURA C&C 32 - 84 Halifax, N.S. On 2013/11/20 9:00 AM, John and Maryann Read wrote: The stainless muffler has finally given up the ghost. It is 6 ¼ round, 2 inch side inlet and 1 ½ inch top outlet, 9 inches high and the base is 7 inches square. Any suggested sources?? Vernalift by Centek Industries makes a close copy but the outlet is 2 inch. On a related note, any thoughts on why the outlet is smaller than the inlet and does this create any backpressure issues?? The engine outlet is 2 inch. On the other hand, this set up has worked well for 30 years so it can't be all bad :) TIA John and Maryann Legacy III 1982 C&C 34 Noank, CT _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com<mailto:CnC-List@cnc-list.com> ________________________________ _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com<mailto:CnC-List@cnc-list.com>
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
