John:
I replaced the SS muffler this past Spring.....don't remember the exact
measurements put similar to yours.
I replaced it with a Vernalift resin muffler....slightly bigger (2"
higher) muffler but with the same 2" inlet and 1 1/2" outlet. I will try
to find my receipt which will have the part # if that helps you. Bottom
line, Vernalift makes a resin muffler with a 1/1/2" outlet. I didn't
want to get into adding hose adapters as my exhaust hoes was replaced
last year and it is 1 1/2". There are no back pressure issues to worry
about with the 1 1/2" outlet with these small marine diesel engines.
Bob Abbott
AZURA
C&C 32 - 84
Halifax, N.S.
On 2013/11/20 9:00 AM, John and Maryann Read wrote:
The stainless muffler has finally given up the ghost. It is 6 ¼
round, 2 inch side inlet and 1 ½ inch top outlet, 9 inches high and
the base is 7 inches square. Any suggested sources?? Vernalift by
Centek Industries makes a close copy but the outlet is 2 inch. On a
related note, any thoughts on why the outlet is smaller than the inlet
and does this create any backpressure issues?? The engine outlet is 2
inch. On the other hand, this set up has worked well for 30 years so
it can't be all bad J
TIA
John and Maryann
Legacy III
1982 C&C 34
Noank, CT
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com
