On 11/08/2017 02:34 PM, Gene Heskett wrote:
On Wednesday 08 November 2017 11:17:54 jeremy youngs wrote:
https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fu
lk%2Fitm%2F121287187940
This is a bit less wait time gene and may be easier to mount
Debatable, the mount bolt spacing is only an inch, and that would put me
drilling and tapping holes right into the motor bearings dust covers
which are only 1/8th inch away. I can make a mount and an extension
shaft) for the Omron with about the same labor. And without endangering
the motor. The outside casting above its brushes can be drilled &
tapped with a lot less worries.
Thanks for the suggestion Jeremy.
Cheers, Gene Heskett
Playing devils advocate....would it be any easier to go analog;
tacho-generator. An op amp with a summing junction and maybe
some filtering is well withing Gene's skill set. The technology may be
old but it still works.
Advice is worth just what you paid for it. ;-)
Dave
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
