On Wednesday 08 November 2017 11:17:54 jeremy youngs wrote: > https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fu >lk%2Fitm%2F121287187940 > > This is a bit less wait time gene and may be easier to mount
Debatable, the mount bolt spacing is only an inch, and that would put me drilling and tapping holes right into the motor bearings dust covers which are only 1/8th inch away. I can make a mount and an extension shaft) for the Omron with about the same labor. And without endangering the motor. The outside casting above its brushes can be drilled & tapped with a lot less worries. Thanks for the suggestion Jeremy. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
