Dan:
One thing with my 2 plugs, both the transducer and the blank, they fit down into the thru hull in an exact position.....yours may be different....but on mine, on both plugs, there are two points that have to be lined up to drop into their respective slots on the thru hull....one obvious reason for this is to ensure you install the padwheel in the correct position, facing forward and not to a side angle....on both plugs, I need a few turns down before I can feel if they are in their slots....I know when things are lined up because I can now longer turn the plug.

But like I said, mine is an old 34 year Signet but it works fine when the padwheel is clean of any debris.

Rob Abbott
AZURA
C&C 32 - #277
Halifax, N.S




On Thu, Oct 11, 2018 at 9:59 AM Dan via CnC-List <cnc-list@cnc-list.com <mailto:cnc-list@cnc-list.com>> wrote:

     or bite the bullet and try pulling the sensor out completely and
    replacing it with the plug which to me sounds like extremely risky
    business but you guys seem to think it's a breeze...

    WISH ME LUCK!

    Dan



_______________________________________________

Thanks everyone for supporting this list with your contributions.  Each and 
every one is greatly appreciated.  If you want to support the list - use PayPal 
to send contribution --   https://www.paypal.me/stumurray

Reply via email to