Thanks, Leslie -------------------------------------------- On Tue, 8/11/15, Josh Muckley via CnC-List <cnc-list@cnc-list.com> wrote:
Subject: Re: Stus-List Yanmar question To: "C&C List" <cnc-list@cnc-list.com> Cc: "Josh Muckley" <muckl...@gmail.com> Date: Tuesday, August 11, 2015, 11:28 AM Yes it should rotate. I think mine is held on with a cotter pin or a clip. Josh Muckley S/V Sea Hawk 1989 C&C 37+ Solomons, MD Yanmar 3HM35F On Aug 11, 2015 2:25 PM, "Leslie Paal via CnC-List" <cnc-list@cnc-list.com> wrote: The "kill" cable broke on my 2GM20, at the engine end. The cause (I think) was that as the arm moved the wire was flexing where it was clamped to the arm. My question: should that clamp (square block of metal with a hole for the wire and a screw to clamp) rotate in the arm. Mine does not. Can be because of corrosion, does not want to force it if it does not meant to rotate... Thanks, Leslie. Phoenix, C&C32 (1983) _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com -----Inline Attachment Follows----- _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
