Yes, but he didn't mention the existence of one. It sounds like it was removed or bypassed and the start push button power moved up stream of the glo-plug button.
Josh On Aug 13, 2015 2:21 PM, "Dennis C. via CnC-List" <cnc-list@cnc-list.com> wrote: > > On Thu, Aug 13, 2015 at 11:24 AM, Josh Muckley via CnC-List < > cnc-list@cnc-list.com> wrote: > >> You didn't mention a solenoid for the glo-plugs. Did i miss that? >> Without a solenoid for the glo-plugs (and fuel pump) then just as the >> second article stated (which is supported by your description of the >> connector) the panel is providing all 24amps of current which is the choke >> point for the pullin voltage of the starter solenoid. When on the shore >> power charger you can see voltages of as much as 14.7v which must be high >> enough to meet the pullin voltage. > > > > The wiring diagram for my Universal 25XPB definitely shows a "Preheat > Solenoid". It also shows the power to the start button coming from the > preheat switch. > > Dennis C. > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
