Edd,

You will probably need a "dump" load for the solar.  They are just
resistive loads.  You can get 12v heater pads that you can attach to the
water tanks or heater.  You could also install a block heater in the
engine.  Most block heaters are designed to be plugged into a wall outlet
but for a dump load the current and voltage are way lower than the rating
on the heater.

Josh Muckley
S/V Sea Hawk
1989 C&C 37+
Solomons, MD
On Mar 26, 2015 5:30 PM, "Edd Schillay via CnC-List" <cnc-list@cnc-list.com>
wrote:

> Listers,
>
> Thanks for all of the advice regarding rewiring the power systems on the
> Enterprise.
>
> Here is link to my draft setup:
> https://dl.dropboxusercontent.com/u/15162917/ENTERPRISE/EnterpriseWiring-Draft.pdf
>
>
> Very crude I know and probably could be considered a mess by any
> respectful wiring diagram standards. Still, I would appreciate listers
> input or just to say "Edd, you got it all wrong. You idiot. Get off our C&C
> List, you amateur hack."
>
> Thanks again. This list is the most valuable part of owning my C&C.
>
>
> All the best,
>
> Edd
>
>
> Edd M. Schillay
> Starship Enterprise
> C&C 37+ | Sail No: NCC-1701-B
> City Island, NY
> Starship Enterprise's Captain's Log <http://enterpriseb.blogspot.com/>
>
>
>
>
>
>
>
>
>
>
>
>
> _______________________________________________
>
> Email address:
> CnC-List@cnc-list.com
> To change your list preferences, including unsubscribing -- go to the
> bottom of page at:
> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
>
>
>
_______________________________________________

Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the bottom of 
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com

Reply via email to