If push comes to shove a machine shop can make one for you.
Josh Muckley
S/V Sea Hawk
1989 C&C 37+
Solomons, MD
On Aug 21, 2014 1:47 PM, "Richard N. Bush via CnC-List" <
cnc-list@cnc-list.com> wrote:
>
> I have run into an unusual problem; I lost a clevis pin from the lower
> shroud, ("someone" didn't spread the cotter pin apart enough), and the pin
> vibrated out under sail; (that was pretty scary!); I thought replacing the
> pin would be easy, but I can't seem to find the part anywhere; the boat is
> a 1985 37 with the original rod rigging, (Navtec I assume); measuring the
> pin from the other shroud I get metric measurements at 1 1/2 MM diameter
> and 4 MM long; I have contacted several sources; (Defender, Rig Rite, Hayn
> and Navtec); all of whom tell me it shouldn't be metric but should be
> imperial measurement; however I tried a 1/2 inch diameter pin in there and
> it is much too small, and 5/8s is too large...I need help; can anyone steer
> me toward a source for the pin? (PS there are no marine riggers or
> facilities in our area, we don't even have a West Marine!);
> Many thanks
>
>
> Richard
> 1985 37, CB Ohio River Mile 584;
>
>
> 2950 Breckenridge Lane, Suite Nine
> Louisville, Kentucky 40220-1462
> 502-584-7255
>
>
>
>
> Email address:CnC-List@cnc-list.com
> To change your list preferences, including unsubscribing -- go bottom of page
> at:http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
>
>
> _______________________________________________
> This List is provided by the C&C Photo Album
>
> Email address:
> CnC-List@cnc-list.com
> To change your list preferences, including unsubscribing -- go bottom of
> page at:
> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
>
>
>
_______________________________________________
This List is provided by the C&C Photo Album
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
