The Rigging loft or (RiggingOnly.com)  in Fairhaven, MA should be able to help. 
They are a very good rigging shop and have been around for a long time.

Thanks,

Mike Fair
413.587.6535

From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Bill Bina - 
gmail via CnC-List
Sent: Thursday, August 21, 2014 1:53 PM
To: cnc-list@cnc-list.com
Subject: Re: Stus-List Stus-clevis pin

Bigger than 1/2 inch and smaller than 5/8... 9/16 inch?

http://www.amazon.com/CLEVIS-PIN-1-7-Stainless-Steel/dp/B000Y82RUY

Bill Bina
On 8/21/2014 1:47 PM, Richard N. Bush via CnC-List wrote:

I have run into an unusual problem; I lost a clevis pin from the lower shroud, 
("someone" didn't spread the cotter pin apart enough), and the pin vibrated out 
under sail; (that was pretty scary!); I thought replacing the pin would be 
easy, but I can't seem to find the part anywhere; the boat is a 1985 37 with 
the original rod rigging, (Navtec I assume); measuring the pin from the other 
shroud I get metric measurements at 1 1/2 MM diameter and 4 MM long; I have 
contacted several sources; (Defender, Rig Rite, Hayn and Navtec); all of whom 
tell me it shouldn't be metric but should be imperial measurement; however I 
tried a 1/2 inch diameter pin in there and it is much too small, and 5/8s is 
too large...I need help; can anyone steer me toward a source for the pin?  (PS 
there are no marine riggers or facilities in our area, we don't even have a 
West Marine!);
Many thanks


Richard
1985 37, CB Ohio River Mile 584;


2950 Breckenridge Lane, Suite Nine
Louisville, Kentucky 40220-1462
502-584-7255





Email address:

CnC-List@cnc-list.com<mailto:CnC-List@cnc-list.com>

To change your list preferences, including unsubscribing -- go bottom of page

at:

http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com






_______________________________________________

This List is provided by the C&C Photo Album



Email address:

CnC-List@cnc-list.com<mailto:CnC-List@cnc-list.com>

To change your list preferences, including unsubscribing -- go bottom of page 
at:

http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com



_______________________________________________
This List is provided by the C&C Photo Album

Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page 
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com

Reply via email to