Bigger than 1/2 inch and smaller than 5/8... 9/16 inch?
http://www.amazon.com/CLEVIS-PIN-1-7-Stainless-Steel/dp/B000Y82RUY
Bill Bina
On 8/21/2014 1:47 PM, Richard N. Bush via CnC-List wrote:
I have run into an unusual problem; I lost a clevis pin from the lower
shroud, ("someone" didn't spread the cotter pin apart enough), and the
pin vibrated out under sail; (that was pretty scary!); I thought
replacing the pin would be easy, but I can't seem to find the part
anywhere; the boat is a 1985 37 with the original rod rigging, (Navtec
I assume); measuring the pin from the other shroud I get metric
measurements at 1 1/2 MM diameter and 4 MM long; I have contacted
several sources; (Defender, Rig Rite, Hayn and Navtec); all of whom
tell me it shouldn't be metric but should be imperial measurement;
however I tried a 1/2 inch diameter pin in there and it is much too
small, and 5/8s is too large...I need help; can anyone steer me toward
a source for the pin? (PS there are no marine riggers or facilities
in our area, we don't even have a West Marine!);
Many thanks
Richard
1985 37, CB Ohio River Mile 584;
2950 Breckenridge Lane, Suite Nine
Louisville, Kentucky 40220-1462
502-584-7255
Email address:
CnC-List@cnc-list.com <mailto:CnC-List@cnc-list.com>
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________
This List is provided by the C&C Photo Album
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________
This List is provided by the C&C Photo Album
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
