I have run into an unusual problem; I lost a clevis pin from the lower shroud,
("someone" didn't spread the cotter pin apart enough), and the pin vibrated out
under sail; (that was pretty scary!); I thought replacing the pin would be
easy, but I can't seem to find the part anywhere; the boat is a 1985 37 with
the original rod rigging, (Navtec I assume); measuring the pin from the other
shroud I get metric measurements at 1 1/2 MM diameter and 4 MM long; I have
contacted several sources; (Defender, Rig Rite, Hayn and Navtec); all of whom
tell me it shouldn't be metric but should be imperial measurement; however I
tried a 1/2 inch diameter pin in there and it is much too small, and 5/8s is
too large...I need help; can anyone steer me toward a source for the pin? (PS
there are no marine riggers or facilities in our area, we don't even have a
West Marine!);
Many thanks
Richard
1985 37, CB Ohio River Mile 584;
2950 Breckenridge Lane, Suite Nine
Louisville, Kentucky 40220-1462
502-584-7255
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________
This List is provided by the C&C Photo Album
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
