I'm not adverse to replacing the tank - but looking online so far I can't find a replacement that matches the shape or the fill holes. The CS tank is 19Gal - and approx 10" wide, 48" long and 6" deep and one end, 12" deep at the other -- a pre-fab new tank would likely require a new mounting set up. Or an expensive custom made tank. I need to examine the tank more closely - but the only pin-hole is on the top of the tank where the steel bracket was holding the tank in place - otherwise with was well supported up out of the bilge and looks to be good. If it's just the one spot from metal contact and the rest of the tank is stable then I might try the POR 15 tank seal product. Need to drain out the diesel and clean it to see what I'm dealing with. Mark --------------------- Dr. Mark Bodnar B.Sc., D.C., FCCOPR(C) Bedford Chiropractic --------------------- There is no cure for birth and death save to enjoy the interval. - George SantayanaOn 10/02/2014 6:02 PM, Rich Knowles wrote:
|
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com