Dear Jason Liu,
In message <12768745743391-git-send-email-r64...@freescale.com> you wrote:
> The patch adds initial support for the Freescale mx53evk board.
> SD/MMC boot is supported
>
> Signed-off-by:Jason Liu <r64...@freescale.com>
In addition to Stefano's comments (he is perfectly right: it makes
zero sense to create another CPU directory, this needs to be unified
with the mx51 support):
> diff --git a/Makefile b/Makefile
> index c26e491..da312c4 100644
> --- a/Makefile
> +++ b/Makefile
> @@ -3301,6 +3301,9 @@ mx31pdk_nand_config : unconfig
> mx51evk_config : unconfig
> @$(MKCONFIG) $(@:_config=) arm arm_cortexa8 mx51evk freescale mx51
>
> +mx53evk_config : unconfig
> + @$(MKCONFIG) $(@:_config=) arm arm_cortexa8 mx53evk freescale mx53
> +
> omap2420h4_config : unconfig
> @$(MKCONFIG) $(@:_config=) arm arm1136 omap2420h4 ti omap24xx
We don't accept such changes to the Makefile any more. Please add your
board to boards.cfg instead. You need to rebase your code against the
"next" branch.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
I wrote my name at the top of the page. I wrote down the number of
the question ``1''. After much reflection I put a bracket round it
thus ``(1)''. But thereafter I could not think of anything connected
with it that was either relevant or true.
- Sir Winston Churchill _My Early Life_ ch. 2
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
