Jason Liu wrote: > The patch adds support for the Freescale mx53 processor. > > Signed-off-by:Jason Liu <r64...@freescale.com> > ---
Hi Jason, > drivers/serial/serial_mxc.c | 7 +++++++ > 1 files changed, 7 insertions(+), 0 deletions(-) > > diff --git a/drivers/serial/serial_mxc.c b/drivers/serial/serial_mxc.c > index 4b93e7b..e488595 100644 > --- a/drivers/serial/serial_mxc.c > +++ b/drivers/serial/serial_mxc.c > @@ -55,6 +55,13 @@ > #define UART_PHYS UART2_BASE_ADDR > #elif defined(CONFIG_SYS_MX51_UART3) > #define UART_PHYS UART3_BASE_ADDR > +#elif defined(CONFIG_SYS_MX53_UART1) > +#define UART_PHYS UART1_BASE_ADDR > +#elif defined(CONFIG_SYS_MX53_UART2) > +#define UART_PHYS UART2_BASE_ADDR > +#elif defined(CONFIG_SYS_MX53_UART3) > +#define UART_PHYS UART3_BASE_ADDR There are really no difference between MX51 and MX53, both set the same values to UART_PHYS (at least as constant: even if the physical address is different, must be unified at this place). I suggest something like CONFIG_SYS_MX_UART1/2/3, that must be used for both MX51 and MX53. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot