Dear Tom, Wolfgang, Can you please let me know the status of the remainging patches of this patch-set. I have not received any reply after sending v3 patch a long time back
These are the Acks I have already received SPEAr : Configuring FSMC driver for NAND interface http://www.mail-archive.com/u-boot@lists.denx.de/msg31656.html SPEAr : FSMC driver support added http://www.mail-archive.com/u-boot@lists.denx.de/msg31655.html SPEAr : i2c driver moved completely into drivers/i2c http://www.mail-archive.com/u-boot@lists.denx.de/msg31604.html SPEAr : USB Device Controller driver support added http://www.mail-archive.com/u-boot@lists.denx.de/msg32362.html SPEAr : macb driver support added for spear310 and spear320 http://www.mail-archive.com/u-boot@lists.denx.de/msg33153.html SPEAr : Network support configured for spear SoCs http://www.mail-archive.com/u-boot@lists.denx.de/msg33152.html Thanks in advance Regards Vipin On 5/28/2010 10:22 PM, Vipin Kumar wrote: > Dear Wolfgang, > > This patch-set as been pending for a long time and it seems Tom is also away > from mails. A few patches have already been Acked by respective device owners > > Please let me know how do I get this patch-set included in 2006.06 release > > Thanks in advance > Vipin > > On Fri, May 14, 2010 at 8:26 AM, Vipin KUMAR <vipin.ku...@st.com> wrote: >> Dear Tom, >> >> I am still waiting for Ack/feedback if any on this patchset v3 >> All feedbacks provided by you on patchset v2 have been incorporated >> >> Regards >> Vipin >> >> On 5/9/2010 7:46 PM, Vipin Kumar wrote: >>> Hello Tom, >>> >>> Please consider this patch-set for mainline submission. >>> Please let me know if there are any changes to be made >>> in code or if the patches are good to go into mainline >>> >>> Thanks & Regards >>> Vipin >>> >>> On Thu, May 6, 2010 at 4:48 PM, Vipin KUMAR <vipin.ku...@st.com> wrote: >>>> Hello Tom, >>>> The following patch-set contains all the accepted feedbacks on patch-set >>>> v2. >>>> Please consider this for submission into mainline >>>> >>>> Below changes are introduced other than the recieved review comments >>>> 1. Introduced a CONFIG_DW_SEARCH_PHY definition, which if defined >>>> searches >>>> the ethernet phy address. Searching was always enabled in earlier patch >>>> 2. Introduced a new function dw_write_hwaddr in ethernet driver and >>>> registered it as a callback via dev->write_hwaddr. This is a new feature >>>> recently implemented by Ben. >>>> >>>> Thanks in advance >>>> >>>> Regards >>>> Vipin >>>> >>>> Vipin Kumar (19): >>>> u-boot.img file not created when srctree and objtree are different >>>> change_bit routine defined >>>> SPEAr : SMI erase and write timeouts increased >>>> SPEAr : Placing ethaddr write and read within CONFIG_CMD_NET >>>> SPEAr : Reducing the max RAM size to 128MB >>>> SPEAr : Basic arch related support added for SPEAr SoCs >>>> SPEAr : Network driver support added >>>> SPEAr : Network support configured for spear SoCs >>>> SPEAr : macb driver support added for spear310 and spear320 >>>> SPEAr : FSMC driver support added >>>> SPEAr : Configuring FSMC driver for NAND interface >>>> SPEAr : i2c driver moved completely into drivers/i2c >>>> SPEAr : smi driver moved completely into drivers/mtd >>>> SPEAr : USB Device Controller driver support added >>>> SPEAr : Supporting various configurations for spear3xx and spear6xx >>>> boards >>>> SPEAr : Basic spear1300 architecture support added >>>> SPEAr : spear1300 SoC support added >>>> SPEAr : Removing extraneous code >>>> SPEAr : USB device controller bugfixes >>>> >>>> MAINTAINERS | 1 + >>>> MAKEALL | 1 + >>>> Makefile | 30 +- >>>> arch/arm/cpu/arm926ejs/spear/Makefile | 3 +- >>>> arch/arm/cpu/arm926ejs/spear/cpu.c | 78 +++ >>>> arch/arm/cpu/arm_cortexa8/spear13xx/Makefile | 52 ++ >>>> arch/arm/cpu/arm_cortexa8/spear13xx/cache.S | 114 +++++ >>>> arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c | 96 ++++ >>>> .../arm_cortexa8/spear13xx/reset.c} | 52 +-- >>>> arch/arm/cpu/arm_cortexa8/spear13xx/timer.c | 138 +++++ >>>> .../arm/include/asm/arch-spear/clk.h | 26 +- >>>> arch/arm/include/asm/arch-spear/hardware.h | 16 +- >>>> arch/arm/include/asm/arch-spear/spr_misc.h | 5 + >>>> .../arm/include/asm/arch-spear13xx/hardware.h | 33 +- >>>> arch/arm/include/asm/arch-spear13xx/spr_gpt.h | 85 ++++ >>>> arch/arm/include/asm/arch-spear13xx/spr_misc.h | 317 ++++++++++++ >>>> .../arm/include/asm/arch-spear13xx/sys_proto.h | 29 +- >>>> arch/arm/include/asm/bitops.h | 11 +- >>>> board/spear/common/Makefile | 10 +- >>>> board/spear/common/spr_misc.c | 28 +- >>>> board/spear/spear1300/Makefile | 51 ++ >>>> board/spear/spear1300/config.mk | 28 + >>>> board/spear/spear1300/spear1300.c | 88 ++++ >>>> .../spear/spear1300/spr_lowlevel_init.S | 35 +- >>>> board/spear/spear300/config.mk | 11 - >>>> board/spear/spear300/spear300.c | 15 +- >>>> board/spear/spear310/config.mk | 11 - >>>> board/spear/spear310/spear310.c | 36 ++- >>>> board/spear/spear320/config.mk | 11 - >>>> board/spear/spear320/spear320.c | 23 +- >>>> board/spear/spear600/config.mk | 11 - >>>> board/spear/spear600/spear600.c | 15 +- >>>> doc/README.designware_eth | 25 + >>>> doc/README.spear | 46 ++- >>>> drivers/i2c/Makefile | 2 +- >>>> drivers/i2c/{spr_i2c.c => designware_i2c.c} | 4 +- >>>> .../spr_i2c.h => drivers/i2c/designware_i2c.h | 6 +- >>>> drivers/mtd/Makefile | 2 +- >>>> drivers/mtd/nand/Makefile | 2 +- >>>> drivers/mtd/nand/fsmc_nand.c | 366 ++++++++++++++ >>>> drivers/mtd/nand/spr_nand.c | 124 ----- >>>> drivers/mtd/{spr_smi.c => st_smi.c} | 59 ++- >>>> .../arch-spear/spr_smi.h => drivers/mtd/st_smi.h | 8 +- >>>> drivers/net/Makefile | 1 + >>>> drivers/net/designware.c | 531 >>>> ++++++++++++++++++++ >>>> drivers/net/designware.h | 264 ++++++++++ >>>> drivers/serial/usbtty.h | 4 +- >>>> drivers/usb/gadget/Makefile | 2 +- >>>> drivers/usb/gadget/{spr_udc.c => designware_udc.c} | 116 +++-- >>>> include/configs/spear-common.h | 33 +- >>>> include/configs/spear13xx_evb.h | 202 ++++++++ >>>> include/configs/{spear3xx.h => spear3xx_evb.h} | 30 ++ >>>> include/configs/{spear6xx.h => spear6xx_evb.h} | 13 + >>>> include/linux/mtd/fsmc_nand.h | 104 ++++ >>>> include/netdev.h | 1 + >>>> include/usb/{spr_udc.h => designware_udc.h} | 6 +- >>>> 56 files changed, 2993 insertions(+), 418 deletions(-) >>>> create mode 100644 arch/arm/cpu/arm926ejs/spear/cpu.c >>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/Makefile >>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cache.S >>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c >>>> rename arch/arm/{include/asm/arch-spear/spr_nand.h => >>>> cpu/arm_cortexa8/spear13xx/reset.c} (50%) >>>> mode change 100644 => 100755 >>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/timer.c >>>> copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear/clk.h >>>> (64%) >>>> copy include/configs/spear6xx.h => >>>> arch/arm/include/asm/arch-spear13xx/hardware.h (58%) >>>> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_gpt.h >>>> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_misc.h >>>> copy include/configs/spear6xx.h => >>>> arch/arm/include/asm/arch-spear13xx/sys_proto.h (64%) >>>> create mode 100644 board/spear/spear1300/Makefile >>>> create mode 100644 board/spear/spear1300/config.mk >>>> create mode 100644 board/spear/spear1300/spear1300.c >>>> copy include/configs/spear6xx.h => >>>> board/spear/spear1300/spr_lowlevel_init.S (56%) >>>> create mode 100644 doc/README.designware_eth >>>> rename drivers/i2c/{spr_i2c.c => designware_i2c.c} (98%) >>>> rename arch/arm/include/asm/arch-spear/spr_i2c.h => >>>> drivers/i2c/designware_i2c.h (98%) >>>> create mode 100644 drivers/mtd/nand/fsmc_nand.c >>>> delete mode 100644 drivers/mtd/nand/spr_nand.c >>>> rename drivers/mtd/{spr_smi.c => st_smi.c} (94%) >>>> rename arch/arm/include/asm/arch-spear/spr_smi.h => drivers/mtd/st_smi.h >>>> (96%) >>>> create mode 100644 drivers/net/designware.c >>>> create mode 100644 drivers/net/designware.h >>>> rename drivers/usb/gadget/{spr_udc.c => designware_udc.c} (91%) >>>> create mode 100644 include/configs/spear13xx_evb.h >>>> rename include/configs/{spear3xx.h => spear3xx_evb.h} (85%) >>>> rename include/configs/{spear6xx.h => spear6xx_evb.h} (82%) >>>> create mode 100644 include/linux/mtd/fsmc_nand.h >>>> rename include/usb/{spr_udc.h => designware_udc.h} (98%) >>>> >>>> _______________________________________________ >>>> U-Boot mailing list >>>> U-Boot@lists.denx.de >>>> http://lists.denx.de/mailman/listinfo/u-boot >>>> >>> >> >> > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
