Dear Wolfgang,
This patch-set as been pending for a long time and it seems Tom is also away
from mails. A few patches have already been Acked by respective device owners
Please let me know how do I get this patch-set included in 2006.06 release
Thanks in advance
Vipin
On Fri, May 14, 2010 at 8:26 AM, Vipin KUMAR <vipin.ku...@st.com> wrote:
> Dear Tom,
>
> I am still waiting for Ack/feedback if any on this patchset v3
> All feedbacks provided by you on patchset v2 have been incorporated
>
> Regards
> Vipin
>
> On 5/9/2010 7:46 PM, Vipin Kumar wrote:
>> Hello Tom,
>>
>> Please consider this patch-set for mainline submission.
>> Please let me know if there are any changes to be made
>> in code or if the patches are good to go into mainline
>>
>> Thanks & Regards
>> Vipin
>>
>> On Thu, May 6, 2010 at 4:48 PM, Vipin KUMAR <vipin.ku...@st.com> wrote:
>>> Hello Tom,
>>> The following patch-set contains all the accepted feedbacks on patch-set
>>> v2.
>>> Please consider this for submission into mainline
>>>
>>> Below changes are introduced other than the recieved review comments
>>> 1. Introduced a CONFIG_DW_SEARCH_PHY definition, which if defined searches
>>> the ethernet phy address. Searching was always enabled in earlier patch
>>> 2. Introduced a new function dw_write_hwaddr in ethernet driver and
>>> registered it as a callback via dev->write_hwaddr. This is a new feature
>>> recently implemented by Ben.
>>>
>>> Thanks in advance
>>>
>>> Regards
>>> Vipin
>>>
>>> Vipin Kumar (19):
>>> u-boot.img file not created when srctree and objtree are different
>>> change_bit routine defined
>>> SPEAr : SMI erase and write timeouts increased
>>> SPEAr : Placing ethaddr write and read within CONFIG_CMD_NET
>>> SPEAr : Reducing the max RAM size to 128MB
>>> SPEAr : Basic arch related support added for SPEAr SoCs
>>> SPEAr : Network driver support added
>>> SPEAr : Network support configured for spear SoCs
>>> SPEAr : macb driver support added for spear310 and spear320
>>> SPEAr : FSMC driver support added
>>> SPEAr : Configuring FSMC driver for NAND interface
>>> SPEAr : i2c driver moved completely into drivers/i2c
>>> SPEAr : smi driver moved completely into drivers/mtd
>>> SPEAr : USB Device Controller driver support added
>>> SPEAr : Supporting various configurations for spear3xx and spear6xx
>>> boards
>>> SPEAr : Basic spear1300 architecture support added
>>> SPEAr : spear1300 SoC support added
>>> SPEAr : Removing extraneous code
>>> SPEAr : USB device controller bugfixes
>>>
>>> MAINTAINERS | 1 +
>>> MAKEALL | 1 +
>>> Makefile | 30 +-
>>> arch/arm/cpu/arm926ejs/spear/Makefile | 3 +-
>>> arch/arm/cpu/arm926ejs/spear/cpu.c | 78 +++
>>> arch/arm/cpu/arm_cortexa8/spear13xx/Makefile | 52 ++
>>> arch/arm/cpu/arm_cortexa8/spear13xx/cache.S | 114 +++++
>>> arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c | 96 ++++
>>> .../arm_cortexa8/spear13xx/reset.c} | 52 +--
>>> arch/arm/cpu/arm_cortexa8/spear13xx/timer.c | 138 +++++
>>> .../arm/include/asm/arch-spear/clk.h | 26 +-
>>> arch/arm/include/asm/arch-spear/hardware.h | 16 +-
>>> arch/arm/include/asm/arch-spear/spr_misc.h | 5 +
>>> .../arm/include/asm/arch-spear13xx/hardware.h | 33 +-
>>> arch/arm/include/asm/arch-spear13xx/spr_gpt.h | 85 ++++
>>> arch/arm/include/asm/arch-spear13xx/spr_misc.h | 317 ++++++++++++
>>> .../arm/include/asm/arch-spear13xx/sys_proto.h | 29 +-
>>> arch/arm/include/asm/bitops.h | 11 +-
>>> board/spear/common/Makefile | 10 +-
>>> board/spear/common/spr_misc.c | 28 +-
>>> board/spear/spear1300/Makefile | 51 ++
>>> board/spear/spear1300/config.mk | 28 +
>>> board/spear/spear1300/spear1300.c | 88 ++++
>>> .../spear/spear1300/spr_lowlevel_init.S | 35 +-
>>> board/spear/spear300/config.mk | 11 -
>>> board/spear/spear300/spear300.c | 15 +-
>>> board/spear/spear310/config.mk | 11 -
>>> board/spear/spear310/spear310.c | 36 ++-
>>> board/spear/spear320/config.mk | 11 -
>>> board/spear/spear320/spear320.c | 23 +-
>>> board/spear/spear600/config.mk | 11 -
>>> board/spear/spear600/spear600.c | 15 +-
>>> doc/README.designware_eth | 25 +
>>> doc/README.spear | 46 ++-
>>> drivers/i2c/Makefile | 2 +-
>>> drivers/i2c/{spr_i2c.c => designware_i2c.c} | 4 +-
>>> .../spr_i2c.h => drivers/i2c/designware_i2c.h | 6 +-
>>> drivers/mtd/Makefile | 2 +-
>>> drivers/mtd/nand/Makefile | 2 +-
>>> drivers/mtd/nand/fsmc_nand.c | 366 ++++++++++++++
>>> drivers/mtd/nand/spr_nand.c | 124 -----
>>> drivers/mtd/{spr_smi.c => st_smi.c} | 59 ++-
>>> .../arch-spear/spr_smi.h => drivers/mtd/st_smi.h | 8 +-
>>> drivers/net/Makefile | 1 +
>>> drivers/net/designware.c | 531
>>> ++++++++++++++++++++
>>> drivers/net/designware.h | 264 ++++++++++
>>> drivers/serial/usbtty.h | 4 +-
>>> drivers/usb/gadget/Makefile | 2 +-
>>> drivers/usb/gadget/{spr_udc.c => designware_udc.c} | 116 +++--
>>> include/configs/spear-common.h | 33 +-
>>> include/configs/spear13xx_evb.h | 202 ++++++++
>>> include/configs/{spear3xx.h => spear3xx_evb.h} | 30 ++
>>> include/configs/{spear6xx.h => spear6xx_evb.h} | 13 +
>>> include/linux/mtd/fsmc_nand.h | 104 ++++
>>> include/netdev.h | 1 +
>>> include/usb/{spr_udc.h => designware_udc.h} | 6 +-
>>> 56 files changed, 2993 insertions(+), 418 deletions(-)
>>> create mode 100644 arch/arm/cpu/arm926ejs/spear/cpu.c
>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/Makefile
>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cache.S
>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c
>>> rename arch/arm/{include/asm/arch-spear/spr_nand.h =>
>>> cpu/arm_cortexa8/spear13xx/reset.c} (50%)
>>> mode change 100644 => 100755
>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/timer.c
>>> copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear/clk.h
>>> (64%)
>>> copy include/configs/spear6xx.h =>
>>> arch/arm/include/asm/arch-spear13xx/hardware.h (58%)
>>> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_gpt.h
>>> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_misc.h
>>> copy include/configs/spear6xx.h =>
>>> arch/arm/include/asm/arch-spear13xx/sys_proto.h (64%)
>>> create mode 100644 board/spear/spear1300/Makefile
>>> create mode 100644 board/spear/spear1300/config.mk
>>> create mode 100644 board/spear/spear1300/spear1300.c
>>> copy include/configs/spear6xx.h =>
>>> board/spear/spear1300/spr_lowlevel_init.S (56%)
>>> create mode 100644 doc/README.designware_eth
>>> rename drivers/i2c/{spr_i2c.c => designware_i2c.c} (98%)
>>> rename arch/arm/include/asm/arch-spear/spr_i2c.h =>
>>> drivers/i2c/designware_i2c.h (98%)
>>> create mode 100644 drivers/mtd/nand/fsmc_nand.c
>>> delete mode 100644 drivers/mtd/nand/spr_nand.c
>>> rename drivers/mtd/{spr_smi.c => st_smi.c} (94%)
>>> rename arch/arm/include/asm/arch-spear/spr_smi.h => drivers/mtd/st_smi.h
>>> (96%)
>>> create mode 100644 drivers/net/designware.c
>>> create mode 100644 drivers/net/designware.h
>>> rename drivers/usb/gadget/{spr_udc.c => designware_udc.c} (91%)
>>> create mode 100644 include/configs/spear13xx_evb.h
>>> rename include/configs/{spear3xx.h => spear3xx_evb.h} (85%)
>>> rename include/configs/{spear6xx.h => spear6xx_evb.h} (82%)
>>> create mode 100644 include/linux/mtd/fsmc_nand.h
>>> rename include/usb/{spr_udc.h => designware_udc.h} (98%)
>>>
>>> _______________________________________________
>>> U-Boot mailing list
>>> U-Boot@lists.denx.de
>>> http://lists.denx.de/mailman/listinfo/u-boot
>>>
>>
>
>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
