Hello Tom,
Please consider this patch-set for mainline submission.
Please let me know if there are any changes to be made
in code or if the patches are good to go into mainline
Thanks & Regards
Vipin
On Thu, May 6, 2010 at 4:48 PM, Vipin KUMAR <vipin.ku...@st.com> wrote:
> Hello Tom,
> The following patch-set contains all the accepted feedbacks on patch-set v2.
> Please consider this for submission into mainline
>
> Below changes are introduced other than the recieved review comments
> 1. Introduced a CONFIG_DW_SEARCH_PHY definition, which if defined searches
> the ethernet phy address. Searching was always enabled in earlier patch
> 2. Introduced a new function dw_write_hwaddr in ethernet driver and
> registered it as a callback via dev->write_hwaddr. This is a new feature
> recently implemented by Ben.
>
> Thanks in advance
>
> Regards
> Vipin
>
> Vipin Kumar (19):
> u-boot.img file not created when srctree and objtree are different
> change_bit routine defined
> SPEAr : SMI erase and write timeouts increased
> SPEAr : Placing ethaddr write and read within CONFIG_CMD_NET
> SPEAr : Reducing the max RAM size to 128MB
> SPEAr : Basic arch related support added for SPEAr SoCs
> SPEAr : Network driver support added
> SPEAr : Network support configured for spear SoCs
> SPEAr : macb driver support added for spear310 and spear320
> SPEAr : FSMC driver support added
> SPEAr : Configuring FSMC driver for NAND interface
> SPEAr : i2c driver moved completely into drivers/i2c
> SPEAr : smi driver moved completely into drivers/mtd
> SPEAr : USB Device Controller driver support added
> SPEAr : Supporting various configurations for spear3xx and spear6xx
> boards
> SPEAr : Basic spear1300 architecture support added
> SPEAr : spear1300 SoC support added
> SPEAr : Removing extraneous code
> SPEAr : USB device controller bugfixes
>
> MAINTAINERS | 1 +
> MAKEALL | 1 +
> Makefile | 30 +-
> arch/arm/cpu/arm926ejs/spear/Makefile | 3 +-
> arch/arm/cpu/arm926ejs/spear/cpu.c | 78 +++
> arch/arm/cpu/arm_cortexa8/spear13xx/Makefile | 52 ++
> arch/arm/cpu/arm_cortexa8/spear13xx/cache.S | 114 +++++
> arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c | 96 ++++
> .../arm_cortexa8/spear13xx/reset.c} | 52 +--
> arch/arm/cpu/arm_cortexa8/spear13xx/timer.c | 138 +++++
> .../arm/include/asm/arch-spear/clk.h | 26 +-
> arch/arm/include/asm/arch-spear/hardware.h | 16 +-
> arch/arm/include/asm/arch-spear/spr_misc.h | 5 +
> .../arm/include/asm/arch-spear13xx/hardware.h | 33 +-
> arch/arm/include/asm/arch-spear13xx/spr_gpt.h | 85 ++++
> arch/arm/include/asm/arch-spear13xx/spr_misc.h | 317 ++++++++++++
> .../arm/include/asm/arch-spear13xx/sys_proto.h | 29 +-
> arch/arm/include/asm/bitops.h | 11 +-
> board/spear/common/Makefile | 10 +-
> board/spear/common/spr_misc.c | 28 +-
> board/spear/spear1300/Makefile | 51 ++
> board/spear/spear1300/config.mk | 28 +
> board/spear/spear1300/spear1300.c | 88 ++++
> .../spear/spear1300/spr_lowlevel_init.S | 35 +-
> board/spear/spear300/config.mk | 11 -
> board/spear/spear300/spear300.c | 15 +-
> board/spear/spear310/config.mk | 11 -
> board/spear/spear310/spear310.c | 36 ++-
> board/spear/spear320/config.mk | 11 -
> board/spear/spear320/spear320.c | 23 +-
> board/spear/spear600/config.mk | 11 -
> board/spear/spear600/spear600.c | 15 +-
> doc/README.designware_eth | 25 +
> doc/README.spear | 46 ++-
> drivers/i2c/Makefile | 2 +-
> drivers/i2c/{spr_i2c.c => designware_i2c.c} | 4 +-
> .../spr_i2c.h => drivers/i2c/designware_i2c.h | 6 +-
> drivers/mtd/Makefile | 2 +-
> drivers/mtd/nand/Makefile | 2 +-
> drivers/mtd/nand/fsmc_nand.c | 366 ++++++++++++++
> drivers/mtd/nand/spr_nand.c | 124 -----
> drivers/mtd/{spr_smi.c => st_smi.c} | 59 ++-
> .../arch-spear/spr_smi.h => drivers/mtd/st_smi.h | 8 +-
> drivers/net/Makefile | 1 +
> drivers/net/designware.c | 531
> ++++++++++++++++++++
> drivers/net/designware.h | 264 ++++++++++
> drivers/serial/usbtty.h | 4 +-
> drivers/usb/gadget/Makefile | 2 +-
> drivers/usb/gadget/{spr_udc.c => designware_udc.c} | 116 +++--
> include/configs/spear-common.h | 33 +-
> include/configs/spear13xx_evb.h | 202 ++++++++
> include/configs/{spear3xx.h => spear3xx_evb.h} | 30 ++
> include/configs/{spear6xx.h => spear6xx_evb.h} | 13 +
> include/linux/mtd/fsmc_nand.h | 104 ++++
> include/netdev.h | 1 +
> include/usb/{spr_udc.h => designware_udc.h} | 6 +-
> 56 files changed, 2993 insertions(+), 418 deletions(-)
> create mode 100644 arch/arm/cpu/arm926ejs/spear/cpu.c
> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/Makefile
> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cache.S
> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c
> rename arch/arm/{include/asm/arch-spear/spr_nand.h =>
> cpu/arm_cortexa8/spear13xx/reset.c} (50%)
> mode change 100644 => 100755
> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/timer.c
> copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear/clk.h
> (64%)
> copy include/configs/spear6xx.h =>
> arch/arm/include/asm/arch-spear13xx/hardware.h (58%)
> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_gpt.h
> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_misc.h
> copy include/configs/spear6xx.h =>
> arch/arm/include/asm/arch-spear13xx/sys_proto.h (64%)
> create mode 100644 board/spear/spear1300/Makefile
> create mode 100644 board/spear/spear1300/config.mk
> create mode 100644 board/spear/spear1300/spear1300.c
> copy include/configs/spear6xx.h => board/spear/spear1300/spr_lowlevel_init.S
> (56%)
> create mode 100644 doc/README.designware_eth
> rename drivers/i2c/{spr_i2c.c => designware_i2c.c} (98%)
> rename arch/arm/include/asm/arch-spear/spr_i2c.h =>
> drivers/i2c/designware_i2c.h (98%)
> create mode 100644 drivers/mtd/nand/fsmc_nand.c
> delete mode 100644 drivers/mtd/nand/spr_nand.c
> rename drivers/mtd/{spr_smi.c => st_smi.c} (94%)
> rename arch/arm/include/asm/arch-spear/spr_smi.h => drivers/mtd/st_smi.h
> (96%)
> create mode 100644 drivers/net/designware.c
> create mode 100644 drivers/net/designware.h
> rename drivers/usb/gadget/{spr_udc.c => designware_udc.c} (91%)
> create mode 100644 include/configs/spear13xx_evb.h
> rename include/configs/{spear3xx.h => spear3xx_evb.h} (85%)
> rename include/configs/{spear6xx.h => spear6xx_evb.h} (82%)
> create mode 100644 include/linux/mtd/fsmc_nand.h
> rename include/usb/{spr_udc.h => designware_udc.h} (98%)
>
> _______________________________________________
> U-Boot mailing list
> U-Boot@lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot
>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
