Add support for LG 9.7" LVDS panel (1024x768) with integrated eGalax
touch screen.

Note that this panel differs only slightly from the Hannstar XGA panel
(margins).

No auto-detection is available because it shares the same touch controller
as the Hannstar-XGA display, so you'll need to configure it through the
'panel' environment variable:

        U-Boot > setenv panel LG-9.7
        U-Boot > saveenv && reset

Signed-off-by: Eric Nelson <eric.nel...@boundarydevices.com>
---
 board/boundary/nitrogen6x/nitrogen6x.c | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/board/boundary/nitrogen6x/nitrogen6x.c 
b/board/boundary/nitrogen6x/nitrogen6x.c
index b2218c9f..fd214ca 100644
--- a/board/boundary/nitrogen6x/nitrogen6x.c
+++ b/board/boundary/nitrogen6x/nitrogen6x.c
@@ -560,6 +560,26 @@ struct display_info_t const displays[] = {{
                .sync           = FB_SYNC_EXT,
                .vmode          = FB_VMODE_NONINTERLACED
 } }, {
+       .bus    = 0,
+       .addr   = 0,
+       .pixfmt = IPU_PIX_FMT_LVDS666,
+       .detect = NULL,
+       .enable = enable_lvds,
+       .mode   = {
+               .name           = "LG-9.7",
+               .refresh        = 60,
+               .xres           = 1024,
+               .yres           = 768,
+               .pixclock       = 15385, /* ~65MHz */
+               .left_margin    = 480,
+               .right_margin   = 260,
+               .upper_margin   = 16,
+               .lower_margin   = 6,
+               .hsync_len      = 250,
+               .vsync_len      = 10,
+               .sync           = FB_SYNC_EXT,
+               .vmode          = FB_VMODE_NONINTERLACED
+} }, {
        .bus    = 2,
        .addr   = 0x38,
        .pixfmt = IPU_PIX_FMT_LVDS666,
-- 
1.9.1

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to