Hi Eric,
On 02/10/2014 21:16, Eric Nelson wrote:
> Several customers are using UART2 (normally the serial console
> for U-Boot) as connections to printers or other peripherals
> that are not tolerant of stray inputs during reset.
>
> Provide a simple way to eliminate output on the serial port
> by conditionally configuring these pads as GPIOs during
> U-Boot.
>
> Signed-off-by: Eric Nelson <eric.nel...@boundarydevices.com>
> ---
> board/boundary/nitrogen6x/nitrogen6x.c | 6 ++++++
> 1 file changed, 6 insertions(+)
>
> diff --git a/board/boundary/nitrogen6x/nitrogen6x.c
> b/board/boundary/nitrogen6x/nitrogen6x.c
> index e795492..621cdbc 100644
> --- a/board/boundary/nitrogen6x/nitrogen6x.c
> +++ b/board/boundary/nitrogen6x/nitrogen6x.c
> @@ -77,9 +77,15 @@ static iomux_v3_cfg_t const uart1_pads[] = {
> MX6_PAD_SD3_DAT7__UART1_TX_DATA | MUX_PAD_CTRL(UART_PAD_CTRL),
> };
>
> +/* #define CONFIG_SILENT_UART */
Theoretically, we have already in U-Boot CONFIG_SILENT_CONSOLE, without
the need to introduce a new CONFIG_.
> static iomux_v3_cfg_t const uart2_pads[] = {
> +#ifndef CONFIG_SILENT_UART
> MX6_PAD_EIM_D26__UART2_TX_DATA | MUX_PAD_CTRL(UART_PAD_CTRL),
> MX6_PAD_EIM_D27__UART2_RX_DATA | MUX_PAD_CTRL(UART_PAD_CTRL),
> +#else
> + MX6_PAD_EIM_D26__GPIO3_IO26 | MUX_PAD_CTRL(UART_PAD_CTRL),
> + MX6_PAD_EIM_D27__GPIO3_IO27 | MUX_PAD_CTRL(UART_PAD_CTRL),
> +#endif
I understand the reason, anyway this looks like a hack (uart is still
configured while iomux is not correctly set). Can you check if your goal
is simply reached with CONFIG_SILENT_CONSOLE ?
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
