Add support for 800x600 18-bit RGB displays using VESA GTF timings.

No auto-detection is supported, so you must configure this panel
manually through the 'panel' environment variable:

        U-Boot > setenv panel svga
        U-Boot > saveenv && reset

Signed-off-by: Eric Nelson <eric.nel...@boundarydevices.com>
---
 board/boundary/nitrogen6x/nitrogen6x.c | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/board/boundary/nitrogen6x/nitrogen6x.c 
b/board/boundary/nitrogen6x/nitrogen6x.c
index b1d85da..6695f87 100644
--- a/board/boundary/nitrogen6x/nitrogen6x.c
+++ b/board/boundary/nitrogen6x/nitrogen6x.c
@@ -640,6 +640,26 @@ struct display_info_t const displays[] = {{
                .sync           = 0x40000002,
                .vmode          = FB_VMODE_NONINTERLACED
 } }, {
+       .bus    = 0,
+       .addr   = 0,
+       .pixfmt = IPU_PIX_FMT_RGB666,
+       .detect = NULL,
+       .enable = enable_rgb,
+       .mode   = {
+               .name           = "svga",
+               .refresh        = 60,
+               .xres           = 800,
+               .yres           = 600,
+               .pixclock       = 15385,
+               .left_margin    = 220,
+               .right_margin   = 40,
+               .upper_margin   = 21,
+               .lower_margin   = 7,
+               .hsync_len      = 60,
+               .vsync_len      = 10,
+               .sync           = 0,
+               .vmode          = FB_VMODE_NONINTERLACED
+} }, {
        .bus    = 2,
        .addr   = 0x48,
        .pixfmt = IPU_PIX_FMT_RGB666,
-- 
1.9.1

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to