The spacing on the elevator horn and the controll stick are the same, I have turnbuckles at the controll stick end for adjustment. I can get 20 down and 30 up, but the control stick is so far back in position when achieving the 30 up, that it seems abnormal.
Bob Sauer ----- Original Message ----- From: "Mark Jones" <flyk...@wi.rr.com> To: "KRnet" <kr...@mylist.net> Sent: Thursday, November 13, 2003 6:45 PM Subject: Re: KR>Elevator/Control Stick Adjustment > The distance of the cable attach points on the bellcrank at the elevator > should be the same distance as those on the control stick. Do you have > turnbuckles as Dan mentioned to tighten and adjust the cables? > > Mark Jones (N886MJ) > > > ----- Original Message ----- > From: "Bob Sauer" <resa...@cox.net> > > > Hi Mark, > > > > They were pre-drilled about equal distance from the stick mounting hole, > > approx. 3" up and down. > > > > > > > > Bob, > > > Where are your cable attach points on the control stick? > > > > > > ----- Original Message ----- > > > From: "Bob Sauer" <resa...@cox.net> > > > > > > > > > I am having a difficult time adjusting the movement of the control stick > > and > > > the elevator. Getting the down 20 degree is possible, but getting the up > > 30 > > > degree with less than deflecting the control stick to the point where > the > > > top of it is at the rear spar is not possible. Does anyone have > > > suggestions. I used the RR center stick and built the elevator control > > horn > > > per plans. I am using cables. > > > > _______________________________________________ > see KRnet list details at http://www.krnet.org/instructions.html
