The connectors can get loose on the back of the control head, as well. Ask me how I know.
Jim Watts Paradigm Shift C&C 35 Mk III Victoria, BC On 6 July 2015 at 14:30, Joel Aronson via CnC-List <cnc-list@cnc-list.com> wrote: > It was just the wire lead to the motor. Pushed it in and tightened the > lock nut. Mine is a little newer X 5 so the connector might be different. I > hope it's that simple for you! > > Joel > > > On Monday, July 6, 2015, dwight veinot via CnC-List <cnc-list@cnc-list.com> > wrote: > >> Thanks Joel, I will check that...can you tell me how to open the motor >> housing in order to see the wires >> >> Dwight Veinot >> C&C 35 MKII, *Alianna* >> Head of St. Margaret's Bay, NS >> d.ve...@bellaliant.net >> >> >> On Mon, Jul 6, 2015 at 5:11 PM, Joel Aronson via CnC-List < >> cnc-list@cnc-list.com> wrote: >> >>> Dwight, >>> >>> I've had the same problem twice, and both times it was a loose wire on >>> the back of the motor. Felt stupid the second time! wonder how I'll feel >>> the third time! >>> >>> Joel >>> >>> On Mon, Jul 6, 2015 at 3:37 PM, dwight veinot via CnC-List < >>> cnc-list@cnc-list.com> wrote: >>> >>>> For some reason my wheel pilot will not send a signal to the drive >>>> motor. It worked fine just after completing the compass deviation >>>> procedure which gave 3 degrees but then when I next went to use it in AUTO >>>> mode nothing happened, no +1 or +10 or -1 or -10 response from the motor >>>> that drives the wheel and therefore no auto steering but everything else, >>>> like heading and rudder angle worked fine. Can anyone shed light on this, >>>> like is there a test that I could do to see if the problem is with the >>>> control unit or the drive motor? >>>> >>>> >>>> Dwight Veinot >>>> C&C 35 MKII, *Alianna* >>>> Head of St. Margaret's Bay, NS >>>> d.ve...@bellaliant.net >>>> >>>> >>>> _______________________________________________ >>>> >>>> Email address: >>>> CnC-List@cnc-list.com >>>> To change your list preferences, including unsubscribing -- go to the >>>> bottom of page at: >>>> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >>>> >>>> >>>> >>> >>> >>> -- >>> Joel >>> 301 541 8551 >>> >>> _______________________________________________ >>> >>> Email address: >>> CnC-List@cnc-list.com >>> To change your list preferences, including unsubscribing -- go to the >>> bottom of page at: >>> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >>> >>> >>> >> > > -- > Joel > 301 541 8551 > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
