Dwight, I've had the same problem twice, and both times it was a loose wire on the back of the motor. Felt stupid the second time! wonder how I'll feel the third time!
Joel On Mon, Jul 6, 2015 at 3:37 PM, dwight veinot via CnC-List < cnc-list@cnc-list.com> wrote: > For some reason my wheel pilot will not send a signal to the drive motor. > It worked fine just after completing the compass deviation procedure which > gave 3 degrees but then when I next went to use it in AUTO mode nothing > happened, no +1 or +10 or -1 or -10 response from the motor that drives the > wheel and therefore no auto steering but everything else, like heading and > rudder angle worked fine. Can anyone shed light on this, like is there a > test that I could do to see if the problem is with the control unit or the > drive motor? > > > Dwight Veinot > C&C 35 MKII, *Alianna* > Head of St. Margaret's Bay, NS > d.ve...@bellaliant.net > > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > > -- Joel 301 541 8551
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
