Thanks Joel, I will check that...can you tell me how to open the motor housing in order to see the wires
Dwight Veinot C&C 35 MKII, *Alianna* Head of St. Margaret's Bay, NS d.ve...@bellaliant.net On Mon, Jul 6, 2015 at 5:11 PM, Joel Aronson via CnC-List < cnc-list@cnc-list.com> wrote: > Dwight, > > I've had the same problem twice, and both times it was a loose wire on the > back of the motor. Felt stupid the second time! wonder how I'll feel the > third time! > > Joel > > On Mon, Jul 6, 2015 at 3:37 PM, dwight veinot via CnC-List < > cnc-list@cnc-list.com> wrote: > >> For some reason my wheel pilot will not send a signal to the drive >> motor. It worked fine just after completing the compass deviation >> procedure which gave 3 degrees but then when I next went to use it in AUTO >> mode nothing happened, no +1 or +10 or -1 or -10 response from the motor >> that drives the wheel and therefore no auto steering but everything else, >> like heading and rudder angle worked fine. Can anyone shed light on this, >> like is there a test that I could do to see if the problem is with the >> control unit or the drive motor? >> >> >> Dwight Veinot >> C&C 35 MKII, *Alianna* >> Head of St. Margaret's Bay, NS >> d.ve...@bellaliant.net >> >> >> _______________________________________________ >> >> Email address: >> CnC-List@cnc-list.com >> To change your list preferences, including unsubscribing -- go to the >> bottom of page at: >> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >> >> >> > > > -- > Joel > 301 541 8551 > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
