On Saturday 22 December 2007 21:35, Frank Sweetser wrote: > Kern Sibbald wrote: > > On Saturday 22 December 2007 19:07, Frank Sweetser wrote: > >> Kern Sibbald wrote: > >>> Could you set: > >>> > >>> export REGRESS_DEBUG=1 > >>> > >>> and run the migration-job-test then send me the output? > >> > >> Here it is. > > > > That is *very* odd. It looks like bconsole just "vanished" -- maybe it > > crashed or something, but it is in the middle of doing something then > > just goes away ... > > > > Could you do an "svn update" on the trunk regress svn, then run that test > > again. I've added one new command that should print some output if > > bconsole gets to it. > > Done, and attached. At a glance, at least, it looks to be pretty much > identical output.
Thanks. Well, I would say that either something is killing bconsole or it is getting some sort of fatal error, something which I have never seen. It is a bit worrisome, but about the only way to track it down would be manually run it. I suggest the following: 1. Modify the script and add an "exit" just after line 77 of tests/migration-job-test. Line 77 reads "END_OF_DATA". 2. Run the script with the "export REGRESS_DEBUG=1" set. 3. When it returns, enter the following commands: bin/bacula start cat tmp/bconcmds | bin/bconsole -c bin/bconsole.conf ps -fax then send me the output. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Bacula-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/bacula-devel
