On 07/15/2020 08:12 AM, Pavlos Basaras via USRP-users wrote:
Dear community,
i am using the usrp n310 device. I am following the start up guide
from
https://kb.ettus.com/USRP_N300/N310/N320/N321_Getting_Started_Guide#Setting_up_a_Serial_Console_Connection
for the initial setup of the usrp.
I completed the installation instructions for the host from
https://kb.ettus.com/Building_and_Installing_the_USRP_Open-Source_Toolchain_(UHD_and_GNU_Radio)_on_Linux
<https://kb.ettus.com/Building_and_Installing_the_USRP_Open-Source_Toolchain_%28UHD_and_GNU_Radio%29_on_Linux>
everything seemed ok.
I can connect to the device through both ssh and by the serial port.
I am trying to use mender to update the filesystem at the usrp device.
I executed the command: sudo uhd_images_downloader -t mender -t n3xx --yes
at the host to obtain usrp_n3xx_fs.mender, which i then copied to the
usrp.
At the usrp i am using the command: mender -rootfs
/home/root/usrp_n3xx_fs.mender
to start the update of the system but i have the following
incompatibility issue :
ERRO[0000] Installation failed: installer: failed to read and install
update: installer: image (device types [ni-sulfur-rev6-mender
ni-sulfur-rev5-mender ni-sulfur-rev4-mender ni-sulfur-rev3-mender
ni-sulfur-rev6 ni-sulfur-rev5 ni-sulfur-rev4 ni-sulfur-rev3]) not
compatible with device ni-sulfur-rev11-mender module=rootfs
ERRO[0000] installer: failed to read and install update: installer:
image (device types [ni-sulfur-rev6-mender ni-sulfur-rev5-mender
ni-sulfur-rev4-mender ni-sulfur-rev3-mender ni-sulfur-rev6
ni-sulfur-rev5 ni-sulfur-rev4 ni-sulfur-rev3]) not compatible with
device ni-sulfur-rev11-mender module=main
How can i resolve this?
Details on the UHD intalled on both the host and the usrp device"
HOST computer uhd: [INFO] [UHD] linux; GNU C++ version 5.4.0 20160609;
Boost_105800; UHD_3.14.1.HEAD-0-g0347a6d8
USRP uhd: [INFO] [UHD] linux; GNU C++ version 7.3.0; Boost_106600;
UHD_3.14.1.1-0-g0347a6d8
all the best,
Pavlos.
This seems a bit odd.
Two things:
(A) How did you copy the .mender file over to the usrp?
(B) (This seems really dumb, and I apologize in advance) are you sure
that you're running the mender command ON the USRP?
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
