Dear Thirumalesha N,
In message
<CAO1Rv-a_hPKfmm2ix_Gc0BgokiQk=qMOnUK4NOmuVxkQWXsn=g...@mail.gmail.com> you
wrote:
>
> > > I have BDI 2000 tool, but its not connecting to board.
> >
> > This is a problem that should be fixable. Keep in mind that the
> > MPC82xx can come up in different modes, depending on if there is a
> > valid HRCW in flash or not. This can change the start address, too.
> > Try both high and low boot configurations.
>
> For reset circuitry HRCW is there. In hardware also its considered.
> if i Want to try for high boot have to change TEXT_BASE address?
In the first place, you must get the BDI working. To do so, you have
to tweak the BDI config file.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
It is better to marry than to burn.
- Bible ``I Corinthians'' ch. 7, v. 9
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
