> > Yes These frequency and flash base address are correct to my board.
> > SMC2 pins PA9-TX and PA8-Rx,
> > I Checked BRG and clock routing is matching to board.
>
> Then you need a debugger.
>
> > I have BDI 2000 tool, but its not connecting to board.
>
> This is a problem that should be fixable. Keep in mind that the
> MPC82xx can come up in different modes, depending on if there is a
> valid HRCW in flash or not. This can change the start address, too.
> Try both high and low boot configurations.
>
For reset circuitry HRCW is there. In hardware also its considered.
if i Want to try for high boot have to change TEXT_BASE address?
Best regards,
Thirumalesha N
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
