Dear Thirumalesha N, In message <cao1rv-zscumej-sbjaneuyf4ipc7bzdqeris-87lp9zk3nu...@mail.gmail.com> you wrote: > > Yes These frequency and flash base address are correct to my board. > SMC2 pins PA9-TX and PA8-Rx, > I Checked BRG and clock routing is matching to board.
Then you need a debugger. > I have BDI 2000 tool, but its not connecting to board. This is a problem that should be fixable. Keep in mind that the MPC82xx can come up in different modes, depending on if there is a valid HRCW in flash or not. This can change the start address, too. Try both high and low boot configurations. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de Remember thee Ay, thou poor ghost while memory holds a seat In this distracted globe. Remember thee! Yea, from the table of my memory I'll wipe away all trivial fond records, All saws of books, all forms, all pressures past, That youth and observation copied there. Hamlet, I : v : 95 William Shakespeare _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
