On 31.01.2012 19:11, Mike Frysinger wrote:
On Tuesday 31 January 2012 12:52:06 Eric Nelson wrote:
Patch 1 modifies the 'sf' command to allow a default bus and chip-select
to be specified by board headers. This allows a bare 'sf' probe command:
U-Boot> sf probe
instead of the more cumbersome usage when a GPIO is tacked onto
the chip-select. Otherwise, this command-line would be needed
to specify GP3:19 on SabreLite:
U-Boot> sf probe 0x5300
Patch 2 provides a description of usage and configuration of CONFIG_CMD_SF.
you can drop these two SF patches from your mx6q series. i don't want to keep
checking to see if you've updated them :p.
Now that part 1, 2, 4 and 5 are merged by Stefano to u-boot-imx.git,
could we get the two part 3 patches merged, too?
Many thanks and best regards
Dirk
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
