On 01.02.2012 12:30, Stefano Babic wrote:
On 31/01/2012 20:14, Eric Nelson wrote:
On 01/31/2012 11:11 AM, Mike Frysinger wrote:
On Tuesday 31 January 2012 12:52:06 Eric Nelson wrote:
Patch 1 modifies the 'sf' command to allow a default bus and chip-select
to be specified by board headers. This allows a bare 'sf' probe command:
U-Boot> sf probe
instead of the more cumbersome usage when a GPIO is tacked onto
the chip-select. Otherwise, this command-line would be needed
to specify GP3:19 on SabreLite:
U-Boot> sf probe 0x5300
Patch 2 provides a description of usage and configuration of
CONFIG_CMD_SF.
you can drop these two SF patches from your mx6q series. i don't want
to keep
checking to see if you've updated them :p.
-mike
I figured as much, but I can't really test them without the rest of the
series...
It does not matter - Mike, what do you think if I merge the whole
patchset into u-boot-imx ? Else the mx6qsabrelite board cannot be built
until all patches will be merged by Wolfgang.
+1
Thanks
Dirk
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
