On Mon, Jul 16, 2018 at 3:10 PM, Maxime Ripard <maxime.rip...@bootlin.com> wrote: > On Mon, Jul 16, 2018 at 01:49:39PM +0530, Jagan Teki wrote: >> Reuse mmc0 node from sun7i-a20.dtsi like other board >> dts files for Primo73 tablet dts file, and drop in dts >> mmc0 definition. >> >> Cc: Siarhei Siamashka <siarhei.siamas...@gmail.com> >> Signed-off-by: Jagan Teki <ja...@amarulasolutions.com> >> --- >> arch/arm/dts/sun7i-a20-primo73.dts | 20 ++++++++++---------- >> 1 file changed, 10 insertions(+), 10 deletions(-) >> >> diff --git a/arch/arm/dts/sun7i-a20-primo73.dts >> b/arch/arm/dts/sun7i-a20-primo73.dts >> index 0658f82675..942a955309 100644 >> --- a/arch/arm/dts/sun7i-a20-primo73.dts >> +++ b/arch/arm/dts/sun7i-a20-primo73.dts >> @@ -62,16 +62,6 @@ >> }; >> >> soc@01c00000 { >> - mmc0: mmc@01c0f000 { >> - pinctrl-names = "default"; >> - pinctrl-0 = <&mmc0_pins_a>, >> <&mmc0_cd_pin_reference_design>; >> - vmmc-supply = <®_vcc3v3>; >> - bus-width = <4>; >> - cd-gpios = <&pio 7 1 0>; /* PH1 */ >> - cd-inverted; >> - status = "okay"; >> - }; >> - >> usbphy: phy@01c13400 { >> usb2_vbus-supply = <®_usb2_vbus>; >> status = "okay"; >> @@ -100,3 +90,13 @@ >> status = "okay"; >> }; >> }; >> + >> +&mmc0 { >> + pinctrl-names = "default"; >> + pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin_reference_design>; >> + vmmc-supply = <®_vcc3v3>; >> + bus-width = <4>; >> + cd-gpios = <&pio 7 1 GPIO_ACTIVE_HIGH>; /* PH1 */ >> + cd-inverted; >> + status = "okay"; >> +}; > > You're not adding the node, you're just moving it around.
ie what I mentioned on the commit message. adding mmc0 node like other board dts files and removing in dts mmc0 node definition. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot