Hi Øyvind, Please explain/specify what is being retired.
When the target reset configuration is specified, there are options: "reset_halt", "reset_init", "reset_run", "run_and_halt", "run_and_init" For example: target arm7tdmi little run_and_init 0 The reset command has the following options: reset ['run'|'halt'|'init'|'run_and_halt' |'run_and_init'] It is said in the documentation that the "optional parameter overrides the setting specified in the configuration file". Do you propose that the target reset configuration is *always* overridden with "reset init"? Why? Best regards, Pieter Conradie -----Original Message----- From: Øyvind Harboe [mailto:[EMAIL PROTECTED] Sent: 17 July 2008 03:00 PM To: Openocd-Dev Subject: [Openocd-development] Retire reset_mode option to target Any objections? The attached patch enforces "reset init" as the behaviour for "reset" (no args) always. This helps reduce confusion. A warning is logged if the deprecated syntax is used. The option old reset_mode option is simply ignored. -- Øyvind Harboe http://www.zylin.com/zy1000.html ARM7 ARM9 XScale Cortex JTAG debugger and flash programmer Notice This email is intended for the addressee only and may contain legally privileged and/or confidential information. If you have received this email in error and are not the intended recipient, you are hereby informed that you are not entitled to read, broadcast, distribute or in any manner whatsoever use the contents of this email or any attachments thereto. You are requested to please notify Psitek that you have received the email and then delete it. Unless clearly stated otherwise, the content and sentiments expressed in this email or any attachments thereto are those of the sender and not of Psitek (Proprietary) Limited. Psitek does not accept liability for any damages, loss or expense of any nature whatsoever arising (a) out of or in connection with the email or any attachments thereto and/or (b) from any act or omission by the recipient relying upon the content of the email or attachments. Psitek further disclaims liability for any damages caused by computer and/or software viruses. Should this email contain the terms of a contract, no binding agreement will result until such time as a written (hardcopy) document is signed on behalf of Psitek. _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
