Hey Mark, Ok, hopefully I can describe this well enough, but please feel free to Email me back with any questions. The bluetooth pairing button is separate from the reset button, and if you've someone sighted helping, it's right next to a bluetooth symbol my girlfriend says is microscopic, but there if you squint... smiley, If you're doing it with out sighted help, hold the Icom with the induction loop facing away from you, with the big flat button facing the floor. Facing the ceiling, on the bottom right is a square metal plate, it'll have your cereal number, a place to right your name, and below that, is your reset button. This isn't the one we need to pair. If you find that reset button, it's just above a screw hole, and run your finger to the left, you'll find a line of the metal square I was talking about earlier, run your finger past that, and you'll feel a small hole, this is the bluetooth button. It happens to be the only button on the bottom left side of the Icom, when it's held in this position. If you hold down this button for 1 minute, it will put the Icom in pairing mode. If you're using someone sighted at this point, they will see the bluetooth indicator flashing blue. This will stay in pairing mode for a few minutes. On the PDF of the manual, it's popping up on pages 26/27, just encase you need to refer to it. The pass code is 4 zero's . Remember to first put the mac in pairing mode, the hit the bluetooth button for the Icom. The manual says that if you're asked which headset to choose, choose stereo, but it works just the same for me if I choose mono. Hope this helps. If you want/need, I can send you a PDF of the manual.
Peace, Nick On 25 Dec 2010, at 10:49, Mark BurningHawk Baxter wrote: > Yes, in fact the factory just replaced it after losing my original Icom, and > it came with the latest upgrades. Then, it had to go back to the factory > again, so they replaced the electronics; it's so spanking new its bum would > be blue if it had one. > > > • Mark BurningHawk Baxter > • AIM, Skype and Twitter: BurningHawk1969 > • MSN: burninghawk1...@hotmail.com > • My home page: > • http://MarkBurningHawk.net/ > > -- > You received this message because you are subscribed to the Google Groups > "MacVisionaries" group. > To post to this group, send email to macvisionar...@googlegroups.com. > To unsubscribe from this group, send email to > macvisionaries+unsubscr...@googlegroups.com. > For more options, visit this group at > http://groups.google.com/group/macvisionaries?hl=en. > -- You received this message because you are subscribed to the Google Groups "MacVisionaries" group. To post to this group, send email to macvisionar...@googlegroups.com. To unsubscribe from this group, send email to macvisionaries+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/macvisionaries?hl=en.
