On 14/05/2016 15:31, Hannu Nyman wrote: > On 14.5.2016 14:03, Felix Fietkau wrote: >> On 2016-05-14 12:56, Hannu Nyman wrote: >>> On 14.5.2016 11:54, John Crispin wrote: >>>> i pushed a tiny patch to fix a regression which i believe was the root >>>> cause for v4.4 not working for most folks. if anyone has time to test >>>> please do so. >>> Sorry but no beef. I still end up in a reboot loop with my WNDR3800. >>> I applied your two 4.4. patches manually to my sources. >>> >>> As far as I could see from the LEDs, the router reboots before the >>> failsafe >>> entrance point is reached. Behaviour looks similar as before your >>> patches. (I >>> have been compiling and trying 4.4 monthly ever since nbd introduced 4.4 >>> support for ar71xx initially and so far every attempt has been a >>> reboot loop.) >> Please send a boot log, I'll look into it as well. >> >> - Felix > > > Here you are. I attached a serial cable to my WNDR3800 and tested both > lede r222 kernel 4.1 build and the new kernel 4.4 build r231 + John's > patches. > > The 4.4 build reboots almost immediately after entering the preinit > phase, right after this line: > random: procd urandom read with 12 bits of entropy available > > Otherwise, in addition to a line about devicetree, I do not notice any > significant difference in boot message shown to the serial console. > I will send the complete bootlogs to Felix and John off-list. > > ---------- > > kernel 4.4 lede r231: > > [ 6.829835] hub 2-0:1.0: USB hub found > [ 6.833837] hub 2-0:1.0: 2 ports detected > [ 6.841699] usbcore: registered new interface driver usb-storage > [ 6.849523] init: - preinit - > [ 7.420202] eth0: link up (1000Mbps/Full duplex) > [ 7.441226] random: procd urandom read with 12 bits of entropy available > รพรพ > > U-Boot 1.1.4 (May 27 2011 - 14:58:01) > > DNI HW ID: 29763654 flash 16MB RAM 128MB (ar7100) U-boot dni25 V0.1 > ------------- > > kernel 4.1 lede r222: > > [ 6.789554] hub 2-0:1.0: USB hub found > [ 6.793555] hub 2-0:1.0: 2 ports detected > [ 6.801445] usbcore: registered new interface driver usb-storage > [ 6.809542] init: - preinit - > [ 7.381367] eth0: link up (1000Mbps/Full duplex) > [ 7.402792] random: procd urandom read with 12 bits of entropy available > Press the [f] key and hit [enter] to enter failsafe mode > Press the [1], [2], [3] or [4] key and hit [enter] to select the debug > level > [ 13.617654] mount_root: Could not open mtd device: /dev/mtd4 > [ 13.623365] mount_root: reading rootfs failed > [ 13.631594] mount_root: loading kmods from internal overlay >
i'll try to reproduce this on my 3700 thanks for testing _______________________________________________ Lede-dev mailing list Lede-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/lede-dev
