On 14.5.2016 14:03, Felix Fietkau wrote:
On 2016-05-14 12:56, Hannu Nyman wrote:
On 14.5.2016 11:54, John Crispin wrote:
i pushed a tiny patch to fix a regression which i believe was the root
cause for v4.4 not working for most folks. if anyone has time to test
please do so.
Sorry but no beef. I still end up in a reboot loop with my WNDR3800.
I applied your two 4.4. patches manually to my sources.
As far as I could see from the LEDs, the router reboots before the failsafe
entrance point is reached. Behaviour looks similar as before your patches. (I
have been compiling and trying 4.4 monthly ever since nbd introduced 4.4
support for ar71xx initially and so far every attempt has been a reboot loop.)
Please send a boot log, I'll look into it as well.
- Felix
Here you are. I attached a serial cable to my WNDR3800 and tested both lede
r222 kernel 4.1 build and the new kernel 4.4 build r231 + John's patches.
The 4.4 build reboots almost immediately after entering the preinit phase,
right after this line:
random: procd urandom read with 12 bits of entropy available
Otherwise, in addition to a line about devicetree, I do not notice any
significant difference in boot message shown to the serial console.
I will send the complete bootlogs to Felix and John off-list.
----------
kernel 4.4 lede r231:
[ 6.829835] hub 2-0:1.0: USB hub found
[ 6.833837] hub 2-0:1.0: 2 ports detected
[ 6.841699] usbcore: registered new interface driver usb-storage
[ 6.849523] init: - preinit -
[ 7.420202] eth0: link up (1000Mbps/Full duplex)
[ 7.441226] random: procd urandom read with 12 bits of entropy available
รพรพ
U-Boot 1.1.4 (May 27 2011 - 14:58:01)
DNI HW ID: 29763654 flash 16MB RAM 128MB (ar7100) U-boot dni25 V0.1
-------------
kernel 4.1 lede r222:
[ 6.789554] hub 2-0:1.0: USB hub found
[ 6.793555] hub 2-0:1.0: 2 ports detected
[ 6.801445] usbcore: registered new interface driver usb-storage
[ 6.809542] init: - preinit -
[ 7.381367] eth0: link up (1000Mbps/Full duplex)
[ 7.402792] random: procd urandom read with 12 bits of entropy available
Press the [f] key and hit [enter] to enter failsafe mode
Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level
[ 13.617654] mount_root: Could not open mtd device: /dev/mtd4
[ 13.623365] mount_root: reading rootfs failed
[ 13.631594] mount_root: loading kmods from internal overlay
_______________________________________________
Lede-dev mailing list
Lede-dev@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/lede-dev
