Just a thought. Drill for a ankle nut. Rivet in place. Fill the whole, thread, top of anchor nut with urethane foam?? Or similar. Then use fuel proof resin on the inside over the Anchor nut area to seal. Then the bolt with screw through the foam. Should work ok. This was a thought of mine if my same senders did the same thing. Phil Matheson
Sent from my iPhone > > I'll give an update when I see how they work. > > In this case, my results may vary.......... > > Larry Flesner > > > _______________________________________________ > Search the KRnet Archives at > https://www.mail-archive.com/krnet@list.krnet.org/. > Please see LIST RULES and KRnet info at http://www.krnet.org/info.html. > see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change > options. > To UNsubscribe from KRnet, send a message to krnet-le...@list.krnet.org _______________________________________________ Search the KRnet Archives at https://www.mail-archive.com/krnet@list.krnet.org/. Please see LIST RULES and KRnet info at http://www.krnet.org/info.html. see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change options. To UNsubscribe from KRnet, send a message to krnet-le...@list.krnet.org
