Ok so let me see if I can explain the fix I would use. I'll call them C plates for lack of a better name. Make a round plate that is 1/4 inch larger and 1/4 smaller than the radius. Mark and drill matching holes and tap them for your screws. Cut the plate in half and insert each in the tank and hold in place with 1 very short screw on each plate. Place the sender in the hole and install very long screws in the remaining holes and start the threads. reach in behind and remove the small screws. Tighten all screws and then remove them and replace with the normal screws one at a time. Hope that make sense.
Craig N6423B N51CW _______________________________________________ Search the KRnet Archives at https://www.mail-archive.com/krnet@list.krnet.org/. Please see LIST RULES and KRnet info at http://www.krnet.org/info.html. see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change options. To UNsubscribe from KRnet, send a message to krnet-le...@list.krnet.org
