Best support for green glass idea is a block of foam as used in bed mattresses with heavy plastic over it. Sit the foam on a piece of board and press up under wing with several little car jacks to get even pressure. Done this heaps when repairing boats, even shaped the board to help get even pressure. On large holes/gaps even put stiff plastic (ice cream container lid, tupaware lid, etc) on top of foam to stop pushing into hole/gap.
regards Barry Kruyssen Cairns, Australia RAA 19-3873 k...@bigpond.com http://www.users.bigpond.com/kr2/kr2.htm ----- Original Message ----- From: Dan Heath It did sag just a little, but I taped it all around. This time, I am going to support from the underside with a support that presses against the wing and hangar floor, to get it a little better. I also used double sided tape for the final installation on that portion of the underside that goes between the two spars.
