Code-wise, You can't have an outlet (adapter or not) with a neutral NEMA 14-x and simply leave that pin unconnected just because your "intended use" doesn't use it. If someone plugs something into there expecting a neutral, it could be dangerous. That said, one thing you could do is saw off or remove the neutral pin on the Tesla 14-30 plug (since it's not connected anyway), and then epoxy up the socket on the adapter, then only the Tesla plug will fit. I did this on my Tesla 14-50 plug so I can also use it on 14-30 dryer outlets without needing a second plug.
Not exactly the fully above board thing, but at least it's safer. If you don't want to do this, at least wire the ground to the "unused" neutral socket, so if someone DID plug something in there, it would be less dangerous than leaving it floating. Keep in mind one day, you will depart this life, you don't want to also force someone who later discovers your adapter to do the same! I have made custom plug adapters for the Tesla Gen 2 UMC, but it requires recovering the overmolded one-wire ID chip from inside the plug, you can't just cut the cable an re-wire it, the UMC will not function. On Mon, Sep 9, 2024 at 6:31 AM EV List Lackey via EV <ev@lists.evdl.org> wrote: > On 9 Sep 2024 at 6:33, Lawrence Rhodes via EV wrote: > > > My Think EVSE finally died, after a decade of use... > > Very sorry to hear of your loss. > > > If I can trust my wife. > > If you can't, you - and she - have more problems than a dead EVSE, and I > don't think that this list can help much. :-\ > > > There is an L-30 twist lock. I need to adapt it to 14-30 to > > accommodate the Tesla EVSE. I saw one diagram that simply didn't > > connect the neutral. Two hots and a ground. Is that acceptable? > > As long as the new EVSE doesn't need 120v for something, that should be > fine. > > IMO, to be 100% safe you should fuse your adapter at 30 amps. The house > breaker protects at 40 amps. Probably very few people do this. I admit, > I > didn't. > > > I vaguely remember combining hot and neutral. > > I'm not an engineer, but I wouldn't do that. I suspect that it will get > you > one or more of 3 things, depending on how it's done: > > - Sparks 'n' arcs > - Tripped house breaker > - Damaged EVSE, if it wants 120v and you hand it 240v > > David Roden, EVDL moderator & general lackey > > To reach me, don't reply to this message; I won't get it. Use my > offlist address here : http://evdl.org/help/index.html#supt > > = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = > > In America, anybody can be president. That's one of the risks > you take. > > -- Adlai Stevenson (1900-1965) > = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = > > _______________________________________________ > Address messages to ev@lists.evdl.org > No other addresses in TO and CC fields > HELP: http://www.evdl.org/help/ > > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.evdl.org/private.cgi/ev-evdl.org/attachments/20240909/9f8c84d3/attachment.htm> _______________________________________________ Address messages to ev@lists.evdl.org No other addresses in TO and CC fields HELP: http://www.evdl.org/help/
