Greetings all; I gave up putting off sleep and with the last of 3 motor top plates 88% done, went to bed around 2ish, knowing it would be done and cold by the time I woke up, which it was.
But the magnetic sheet used for a build surface was welded to the hot plate pretty bad, and by the time I had gotten the putty knife under it and pried it loose, and lifted free, both the bottom of the mag sheet and the tan pad glued to the build plate were surface damaged. Has anyone else encountered this? As time and use have gone by, part adhesion to the build surface has improved to the point the brim has become permanently stuck, sometimes coming off with the next part so that hasn't been a huge problem yet, but is that how it works, making the whole build plate an assembly one should keep on hand? Thanks. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
