"Someone on another group mentioned sending P; to the KPA500 would turn the amp on provided to main power switch was on. Can you confirm that?"
The power on command is P not P; >From the programmer's reference - "BootLoader Command Reference The KPA500 uses single character commands when in boot mode. Boot mode is the state the KPA500 is in when the rear panel power switch is in the ON position, while the main firmware is not running. This mode is used for starting up the KPA500 or downloading fresh firmware. Bootloader commands must be sent upper-case only. P Power On The P command will cause the KPA500 to perform internal firmware checks, then execute the main firmware to power up the amplifier. This is the command to use to remotely power up the KPA500. No response is sent from the KPA500 after receiving this command." Andy, k3wyc ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
