I use the KAT500 remote software and it works great. I have only one
problem with it, I can not tell if the power is on or off. This matters
because when the remote site looses power the state of the KAT500 is
unknown and the program does not indicate if the power is ON or OFF. Is
there a way to tell?
I can keep trying the POWER button then the TUNE button until it works,
but it would be much better for a positive indication of the power state
by button color or some other indication in the application.
I have set the "Initial Power" in the KAT500 utility to be "Power On"
when DC is applied, but not sure this is always observed. I have no
other way to see the remote site when this happens.
Any suggestions?
Gordon - N1MGO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
