I do the same except I use a machine screw with a nylock to hold them
together, so if they ever have to come apart again...

Jim Watts
Paradigm Shift
C&C 35 Mk III
Victoria, BC

On 25 May 2017 at 18:57, Bruce Whitmore via CnC-List <cnc-list@cnc-list.com>
wrote:

> Dennis,
>
> I like it!  Have had to deal with similar situations and really like your
> solution.  I'd probably go even further and coat the center on both sides
> with liquid electrical tape.
>
> Kindest Regards,
>
> Bruce
> 847.404.5092 <(847)%20404-5092>
>
> Please forgive any typos as this was sent from my iPhone.
>
> On May 25, 2017, at 6:05 PM, Dennis C. via CnC-List <cnc-list@cnc-list.com>
> wrote:
>
> Had a situation where I wanted to connect two wires twisted and soldered
> together with two smaller individual wires.  The individual wires could use
> a 14-16 connector but the twisted wires needed a 10-12 connector.
>
>  Aha!  I grabbed two 14-16 #10 ring connectors and a 10-12 #10 ring
> connector and riveted them together with a 3/16 inch 1/4 inch grip aluminum
> rivet.  Everything got smeared with TefGel since the rivet wasn't tinned
> marine grade.  Voila, a 3 way connector with two 14-16 connectors and one
> 10-12 connector.
>
> https://drive.google.com/open?id=0B_sb5TfIENvseWVpb0h0WUVvVnc
>
> Yeah, I could have used a couple of 10-12 butt connectors and twisted
> wires together and folded wires over but that's not how we roll on
> Touche'.  Could have also used a piggy back quick disconnect.
>
> Dennis C.
>
> _______________________________________________
>
> This list is supported by the generous donations of our members. If you
> wish to make a contribution to offset our costs, please go to:
> https://www.paypal.me/stumurray
>
> All Contributions are greatly appreciated!
>
>
> _______________________________________________
>
> This list is supported by the generous donations of our members. If you
> wish to make a contribution to offset our costs, please go to:
> https://www.paypal.me/stumurray
>
> All Contributions are greatly appreciated!
>
>
_______________________________________________

This list is supported by the generous donations of our members. If you wish to 
make a contribution to offset our costs, please go to:  
https://www.paypal.me/stumurray

All Contributions are greatly appreciated!

Reply via email to