Charlie, I have the original aluminum dip pole and 2 sets of lines. Jake has a carbon pole for his 35/3 and does end for end.Getting the pole back on the mast in a blow could be a major accomplishment! If I had a new pole I'd be tempted to do end for end in light air and dip in heavy air, or use my asym and screw the pole completely.
Joel 35/3 Annapolis On Tue, Apr 29, 2014 at 1:13 PM, Hoyt, Mike <mike.h...@impgroup.com> wrote: > The CC115 uses Dip Pole. It has a different end on each end of pole. > > > > *From:* CnC-List [mailto:cnc-list-boun...@cnc-list.com] *On Behalf Of * > cenel...@aol.com > *Sent:* Tuesday, April 29, 2014 2:10 PM > > *To:* cnc-list@cnc-list.com > *Subject:* Re: Stus-List Spinnaker handling > > > > All this talk of spinnaker handling has me wondering. > > > > Do most of you use end for end spin pole handling for jibing or dip pole? > If dip pole, do you use 2 sets of lines? > > > > We are trying to get the foredeck dance down with dip pole jibes since it > should be easier on the foredeck crew, especially in winds above 10 knots. > > > > Even with a carbon pole, 14 + feet is a little unwieldy in a breeze for > end for end jibes. > > > > Charlie Nelson > > Water Phantom > > C&C 36 XL/kcb > > > > > > cenel...@aol.com > > > > > > -----Original Message----- > From: Joel Aronson <joel.aron...@gmail.com> > To: cnc-list <cnc-list@cnc-list.com> > Sent: Tue, Apr 29, 2014 1:03 pm > Subject: Re: Stus-List Spinnaker handling > > Tim. > > > > If you are going to douse and gybe you will need to clear the primary in > order to sheet the gennie. > > > > Joel > > > > On Tue, Apr 29, 2014 at 12:49 PM, Tim Goodyear <timg...@gmail.com> wrote: > > Primaries would be for the guys. Should have pointed that part out; we > use symmetrical chutes. > > > > Thanks, > > > > Tim > > > On Apr 29, 2014, at 12:28 PM, "Hoyt, Mike" <mike.h...@impgroup.com> wrote: > > The sheets would still go aft to the same position for block and then > bring them forward to whatever winch. I would suggest that you do not need > the primaries while flying chute and that should be what you use for the > spin sheet. > > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > CnC-List@cnc-list.com > > > > > > -- > Joel > 301 541 8551 > > _______________________________________________ > > This List is provided by the C&C Photo Album > > http://www.cncphotoalbum.com > > CnC-List@cnc-list.com > > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > CnC-List@cnc-list.com > > -- Joel 301 541 8551
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
