Internet wisdom says that if you don't mind removing the shaft, a hack saw threaded up the cutlass will remove it and a length of all thread and some washers will install it. Let us know what works.
Good luck, Josh On Dec 13, 2013 9:54 AM, "Joel Aronson" <joel.aron...@gmail.com> wrote: > For 50 I would buy it. The one I saw was 400! Can you point me in the > right direction? > > On Friday, December 13, 2013, Josh Muckley wrote: > >> Nope, but if you end up buying one... I remember seeing one where you >> didn't have to remove the shaft. I think it ran about $50. >> >> Josh >> On Dec 13, 2013 8:28 AM, "Joel Aronson" <joel.aron...@gmail.com> wrote: >> >>> All, >>> >>> Does anyone in the Annapolis area have a cutlass bearing removal tool >>> for a 1 inch shaft that I could borrow? >>> >>> Thanks! >>> Joel >>> 35/3 >>> The Office >>> Annapolis >>> >>> >>> -- >>> Joel >>> 301 541 8551 >>> >>> _______________________________________________ >>> This List is provided by the C&C Photo Album >>> http://www.cncphotoalbum.com >>> CnC-List@cnc-list.com >>> >>> > > -- > Joel > 301 541 8551 > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > CnC-List@cnc-list.com > >
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
