That's a deal!
Joel

On Friday, December 13, 2013, Ron Kaye wrote:

>
> Hi Joel,
> If and when you get this and decide to proceed I would like if possible to
> assist and observe. Not sure what I can do exactly but fetching a hot latte
> from Starbucks is a start.  If it works out just let me know time and
> coordinates. I'm about 75 minutes away and I'll cut and run if I can.
>
> Ron
> of the People's Republic of Ron and Lisa
> Mr Bop
> 35/3
>
> On Dec 13, 2013, at 9:54 AM, Joel Aronson 
> <joel.aron...@gmail.com<javascript:_e({}, 'cvml', 'joel.aron...@gmail.com');>>
> wrote:
>
> For 50 I would buy it. The one I saw was 400!  Can you point me in the
> right direction?
>
> On Friday, December 13, 2013, Josh Muckley wrote:
>
>> Nope, but if you end up buying one... I remember seeing one where you
>> didn't have to remove the shaft.  I think it ran about $50.
>>
>> Josh
>> On Dec 13, 2013 8:28 AM, "Joel Aronson" <joel.aron...@gmail.com> wrote:
>>
>>> All,
>>>
>>> Does anyone in the Annapolis area have a cutlass bearing removal tool
>>> for a 1 inch shaft that I could borrow?
>>>
>>> Thanks!
>>> Joel
>>> 35/3
>>> The Office
>>> Annapolis
>>>
>>>
>>> --
>>> Joel
>>> 301 541 8551
>>>
>>> _______________________________________________
>>> This List is provided by the C&C Photo Album
>>> http://www.cncphotoalbum.com
>>> CnC-List@cnc-list.com
>>>
>>>
>
> --
> Joel
> 301 541 8551
>
> _______________________________________________
> This List is provided by the C&C Photo Album
> http://www.cncphotoalbum.com
> CnC-List@cnc-list.com <javascript:_e({}, 'cvml',
> 'CnC-List@cnc-list.com');>
>
>

-- 
Joel
301 541 8551
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com

Reply via email to